PEUGEOT 504 Series 1970 Workshop Manual page 274

DIFFERENTIAL
RE-ASSEMBLY· ADJUSTMENT
8· 69
Supersedes sheet class 5, page 03 18
. Remove the two differential bearing thrust
plates
1.
- Remove the two oil seols2 using a press.
N.B. ·
It is possible to effect this operation,
with the differential mounted on the car, using
:i
tyre lever.
- Remove grease from new bearings and install
some using :
· o press,
. fitting tool 8,
· press pod
H2
· Oil bearings with plenty of ESSO EXTRA
MOTOR OIL 20 W 30/ 40. No other lubricant
should
be
used.
Assembling the differential mechanism
· Place housing vertically in vice,
· Apply Perfect Seal on machined surface of
housing .
. Apply oil on housing bearing recesses
· Install crown gear differential assembly
· Install rear cover by means of 4 nuts 3 equip-
ped with new Onduflex washers and tighten to
5.8 ft.lbs
(0.8 m.kg).
Install bearing side plate
4
(left hand side)
without shims. Fitthe4 bolts
5
with new Ondu-
flex washers.
Tightening torque 5.8 ft.lbs
(0.8 m.kg)
• Slacken nuts 3 and tighten them by hand.
504 Workshop Monuol · Ref. 1212 E