PEUGEOT 504 Series 1970 Workshop Manual page 427

BRAKES
REPLACING A REAR DISC
II - DISC MOUNTED ON THE INSIDE OF HUB.
1st fitting to Coupe/ Convertible
REMOVE
- Raise vehicle at rear jacking point.
-
D1sen~ge
the arms, brake pipe and flexible hose.
- Dismantle the drive shaft (1) by disconnecting the
redr cross n1embcr.
- Hold the cross-member temporarily in place by
means of the tornrny-bars
(J).
- Rorrovc the pads.
- Partially dismantle the caliper without disconnecting
the brake pipe.
- Proceed as shown to remove the hub nut.
·retain the screw C1 whilst in this position.
WVIW. ~~lllC:J . OrG