PEUGEOT 504 Series 1970 Workshop Manual page 513

REAR SUSPENSION
SU SP EN SION CROSSM EMBER
REFITTING
A· On car
·Place the rubber thrust cups on the suspension
crossmember ofter smeoring them with pure
Teepol to facilitate their positioning.
• Properly engage the crossmember between the
differential and the hull.
- F 1t the crossmember under the bodywork then
secure using the following :
- rubber wo shers
- sheet metal cups
- nuts and new Blocfor washers. Tighten the
nuts to
23.5
ft.lbs (3.25 m.kg).
IMPORTANT :
Check for condition of iMerchonge0bil ity between
suspension crossmember, spacer and rubber seat·
ing cups. (see class
9, page 11 03).
- Stick the rear springs upper rubber cups in their
recess in the crossmember.
- Place the springs between their upper and
lower supports.
· Lower the rear of the car and posit ion the
springs in their upper cups.
- F it the shock absorbers (class
9, page 15 02).
·Do not tighten the lower securing nuts.
· Install the wheels and tighten to
43
ft.lbs
(6 m.kg).
- Lower the car onto its wheels.
· Place a jock under the right hand lateral holder
and raise the crossmember until it comes into
contact with the floor.
· Remove guide rod Kl.
·Close the guide hole using the plastic plug.
·Fit the following on the studs in the indicated
order : - flat washers · a new tab lock - the
securing nuts.
· The nuts must be tightened either at :
- 29 ft.lbs (4 m.kg) up to the serial numbers
mentioned below, or - 47 ft.lbs (6.5 m.kg) os
from the same serial numbers :
· 504 AOl · 1 005 546 504 A02 - 1 003
649
504 A03 • beginning of series
- 504 802 - 1 032
357
504 C02 - 1 009 769
·Lock by bending the tab tongues over the nuts.
·To secure the rear crossmember carry out the
some operations on the left hand side.
- Refit the rear seat cushion.
WVIW. ~~illCJ . OrG