PEUGEOT 504 Series 1970 Workshop Manual page 498

0
w
lj
~
w
a.
FRO NT SUSPEN S IO t-\
REFITTING A FRONT SU SPENSION ELEMENT
• Amply grease the need le thrust beor ing using
ESSO MULTI PURPOSE GREASE H.
·Place the following on the upper spr ing hol-
der
1 :
·thrust plate 2 with its collar facing down·
words,
• need le bearing 3, with the needles foe ing
upwards,
• bearing oi I seal 4 with the big Ii p pointing
downwards,
- bearing thrust plate 5, its seal facing down-
wards,
·Shim 6.
·F it the following on the supporting element
- suspension spring 7,
·upper spring cup 8,
·upper holder assembled 9.
- Hold this assembly using compressor A.
- Compress the spring by tightening alternately
both operating bolts. Ensure free engagement
of the shock absorber rod in the Support recess.
·Fit safety cup
10
with its tab 1n the SuppOl't
groove.
·Fit a new Nylstop nut and tighten to 33 ft .lbs
(4.5 m. kg) while holding the rod with socketM
• Remove :
·spring compressor A,
·rod holding clomp L,
·Engage rod rubber boot over the clos ing nut.
50d Workshop Mo nuo I • Rei. 1212 E
WVIW.
!::a~
ICI .OrG