PEUGEOT 504 Series 1970 Workshop Manual page 300

0
w
~
::>
w
Q.
Supersedes sheel class 5, poge 1507 (1)
REAR AXLE
REAR CROSSMEMBER
- Raise the car at the rear and chock it under
the lateral crossmember supports.
- Low er the rear of the car unt i I the securing
studs on the crossmember are positioned.
- Remove the two guides K 1 and fit in order :
- the plastic guide hole plugs.
- the six flat washers.
- the two tab locks.
- the six nuts must be tightened either
at - 29 ft. lbs (4 m.kg) up to the serial numbE:rs
mentioned below
or - 47 ft.lbs (6.5 m.kg) as from the same
serial numbers :
504
AOl • 1 005 546
504 A02 • 1 003 649
504 A03 ·beginning of series
504 802 • 1 032 357
504 C02 - 1 009 769
- Lock the nuts by turning the tabs up around
the nuts.
- Coat the rubber stop rings with pure T eepo
I.
- Introduce the outer cable ends in their respec-
tive guides.
- Replace the protector covers.
- Refit the handbrake control equipped with a
new relay arm.
504 Workshop Manual - Ref. 1212E