PEUGEOT 504 Series 1970 Workshop Manual page 162

0
w
IJ
~
w
0.
GEARBOX
REFITTING
• Smear Molykote
321
on the front part of the
engine drive shaft os well os in the thrust boll
bearing guide sleeve.
·Engage the thrust boll bearing by positioning
its retaining jaw l towards the starter motor
housing.
- Engage thrust bearing with clutch release fork
by rotating the bearing clockwise.
• Properly position the gearbox and engage the
engine drive shaft with the clutch disc without
using too much force.
·Secure the gearbox by means of three Allen
screws equipped with new Grower washers.
The tightening torque is 40 ft.lbs
(5.5
m.kg).
• Remove the block placed under the radiator.
- Lower the hoisting oppcrotus and remove hooks
E and G.
- Place the support base
8.0125
os for removal.
·Align the engine-gearbox assembly with the
propeller shaft by means of the opero1ing
screw.
• Smear MUL TIPURPOSE
GREASE 'H on the
propeller shaft splines.
WVIW. E. CJ llCJ .OrG