PEUGEOT 504 Series 1970 Workshop Manual page 190

0
w
~
:J
w
a.
GEARBOX
RE-ASSEMBL Y
• Pos1t1on R.H. housing
1
and secure with the
four housing bolts 2 (Hand tight only).
·Secure rear plate 3 using the 4 Allen screws
(h and tight only'.
· Make sure the knurled head screws ore tighte·
ned on support base 8.0311 and clomp base
vertically
tn
a vice, with the front port of the
gearbox facing upwards.
·Place installing drift S on intermediate geor-
shaft front bearing and press downwards.
- Rotate the shaft to position the bearings.
• Install the clutch housing and secure with four
bolts installed either side of the gearbox half
housing mating surfaces.
- Tighten the following bolts
· clutch housing bolts,
·gearbox hous mg bolts,
· rear plate bolts
T ightening torque. 7.2 ft.lbs (1 m.kg)
·Remove the clutch housing.
504 Workshop Manual • Ref 1212 E
WWW.!::::. c:J Cl .OrG