PEUGEOT 504 Series 1970 Workshop Manual page 304

I
0
w
\J
:>
w
Q.
REAR AXLE
REAR CROSSMEMBER
REFITTING OF A REAR CROSSMEMBER
- Secure the intermediate support to the cross
member using new star washers.
- Tighten the bolts to 23.5 ft.l bs (3.25 m.kg).
- Then fit the crossmember support to the rubber
blocks using new star washers and o new
locking washer.
- Tighten the two front nuts to 13 ft. lbs (1 75
m.kg)ondthe rear nut to 23. 5 ft. lbs (3.25 m.kg)
and lock by bending the tab tongues over the
nut.
- Fit the guide Kl to the crossmember support.
- Place o jock under this support and raise
it unti I the three cross member studs ore com-
pl etely engaged.
- Remove the guide K 1 and fit in order :
- the plastic guide hole plug.
- the three flat washers.
- the tab lock.
- the three nuts must be tightened either at :
29 ft. lbs (4 m.kg) up to the serial numbers
mentioned below, or :
47
ft .lb s (6.5 m.kg) as from the some serial
numbers .
504 AOl - 1 005 546
504
A02 - 1 003 649
504
A03 - beginning of series
504
802 - 1 032 357
504
C02 - 1 009 769
·Lock by bending the tab tongues over the nuts.