PEUGEOT 504 Series 1970 Workshop Manual page 195

I
~
~-®
~-©
---=--=--
GEARBOX
RE-ASSEMBLY
DRIVE SHAFT
·Remove the bearing (see class 3, page 03 07).
·Place the following on the shaft, respecting
the indicated order .
- adjustment shims 1 previously determined
(adjustment n° 1),
- deflector washer 2.
- Re-install bearing 3 (see class 3, page 03 19).
- Install spring washer 4 and snap ring 5.
- Place this assembly on the table of the press
resting on spacer G.
- SI de installing drift U over the drive shaft
with the hollow section of the drift downwards.
- Exert a slight force with the press to compress
the spring washer and align the snap ring with
its groove.
- Use combination pliers to squeeze the snap
ring until its outside diameter is the some as
that of drift U.
WWW. !::ii CJ Cl. .OrG
I
I