PEUGEOT 504 Series 1970 Workshop Manual page 532

0
w
lj
:::>
w
a.
Supersedes sheet doss 11, poge 0225 (I)
BODYWORK
REFITTING
At the rear :
- Raise the body to allow for engagement of
guide rods
Kl
into the guide holes.
- Simultaneously screw in both nuts l of the
holding apparatus until crossmember support
studs 2 on the body start to engage.
- Chock from under the crossmember lateral sup-
ports.
- Lower the rear of the car unti I the crossmember
securing studs ore in their position.
- Remove guide rods
Kl
and fit in the following
order :
- the guide hole plastic plugs,
- the six flat washers,
- the two tab locks
- the six nuts. Tightening torque : up to the fol-
lowing serial numbers : 29 ft.lbs (4 m.kg) and
as from the following numbers : 47 ft.lbs
(6.5 m.kg).
504 AOl -
1 005 546
504 802 -
1 032 357
504 A02 -
1 003 649
504 C02 -
1 009 769
504 A03 - beginning of series
- Lock by bending the tab lock tongues over :he
nuts.
- Refit the rear seat cushion.
- Lower the rear of the car on its wheels.
- Remove :
- the chain hoist,
- the rear crossmember holding apparatus.
- Refitthe broking compensator lever using a new
circlip.
- Smear the anti-rol I bar bushes with molykote G.
- Position and secure the anti-roll bar under the
bodywork.
- Refit the rear exhaust pipe.
- Remove the cloth placed at removal in the anti-
roll bar connecting rod holes on the rear cross-
member.
504 Workshop Manual • Ref. 1212 E
WVIW.
!::a~
ICI .OrG