PEUGEOT 504 Series 1970 Workshop Manual page 302

I
0
w
\J
:J
w
0..
REAR AXLE
REAR CROSS MEMBER
0
Jll
REMOVAL OF A REAR CROSS MEMBER SUP-
PORT
- Place the car over a pit or on a car lift.
- Unscrew the nut securing the rear broke hose
to th e support on the rear floor.
- Remove the hose from the support.
- Unlock the rear support shouldered nut on the
rear block.
- Posit ion a ock under the rear cross member
support
in
contact with it.
- Remove the rear seat cushion.
- Unlock the three cross member securing bolts.
- Remove the front securing nut.
- Raise the tab lock and remove the plastic
plug from the guide hole.
- Screw into this hole the guide
Kl
and tighten
it using the bar K2.
- Remove the bar K2.
- Remove the rear securing nuts of the cross
member and the thrust washers.
- lower the cross member unt
i
I the guide is
disengaged from the bodywork.
504 Workshop Monuol •Rei. 1212 E