PEUGEOT 504 Series 1970 Workshop Manual page 198

Supersedes sheet class 3, page 03 33
GEARBOX
RE-ASSEMBLY
e~JJr
- Install the speedometer drive socket with o new
«0» ring smeared with toll ow; use pi iers
H
ond
position the ports by rotating them.
· lnstoll the drive socket stop screw together
with its lock nut.
·Working inside the clutch housing, proceed os
follows :
- insert rubber cup 1 in the groove behind the
boll head thrust 2 ond fill with greose.
- coot guide sleeve 3 sparingly with Molykote
grease.
- Slide clutch release fork 4 from the inside
towards the outside of the housing.
- Use o screwdriver to raise clutch release fork
backing spring 5.
- Engage the fork on the boll head with the spring
pressing on the rubber cup.
• Fit the reverse I ights switch 6, equipped with a
new seal.
- For switches with copper body and metollo-
plostic gasket tighten to 9 ft.lbs (125 m.kg).
- For switches with steel body ond copper gasket
tighten to
20
ft.lbs
(2.75
m.kg).
504 Work shop Manual - Ref. 1212 E
WVIW. E. CJ llCJ .OrG