PEUGEOT 504 Series 1970 Workshop Manual page 434

BRAKES
REPLACING A REAR DISC
- Mount the dial indicator as shown.
- When rotated one complete turn disc run-out must
not exceed, 0,07 m/m.
- If this limit is exceeded, rotate the disc one-half
turn, in relation to the hub, and re-check run-out.
- Remove tools
(Cl)
and
(C2).
-
Stake the hub carrier nut.
- Coat the drive shaft spl ines with Molykote 321.
- Fit dnve shaft to hub.
- Replace the assembly in vehicle.
- Mount each bolt (brushed clean) with .
- a new washer.
- a few drops of Loctite, (standard grade).
- Torque to, 31 ft/lbs. (4,5 m.kg.).
- Torque shaft nut to,
181
ft/lbs. (25 m.kg.) and
stake .
.
...
'.
Ref. 1212 ·E.