PEUGEOT 504 Series 1970 Workshop Manual page 383

STEERING GEAR
STEERING
COLUMM
- Grease thoroughly the lower steering column
bush, which is fitted tn the sealing plate.
- Insert the lower steering column rod in its
bearing and in the fle ctor collar.
- Push the rod home into the flector.
- Fit the upper assembly of the steering column.
- Connect simultaneously the two parts of the
gear change control rod and the steering column
- Using new star washers, fit and tighten the 4
nuts securing the steering column, under the
dashborad to 7.2 ft.lbs (1 m.kg).
- Fit a new Mecanindus pin, to assemble the
gear change control rods.
- Pos1 t1on the retaining clip over the pin.
- Secure the lower part of the cordon roint on the
steering column using a new bolt nut and
Bloctor washer.
- Tighten the nut to 7.2 ft.lbs (1 m.kg) and lock
it by spreading the protruding end of the bolt.
- Reconnect :
- the Neiman anti-theft lock wires
- the 3 wiring harness connectors on the steerrng
column
- Secu•e the harness under the doshborod.