PEUGEOT 504 Series 1970 Workshop Manual page 159

GEARBOX
REMOVAL
. Separate the connecting tube from the gearbox
by about 20 mm .
• Insert propeller shaft holding plate 8 .0403 S
between them.
·Using two MlO
X
150 bolts secure the plate at
the lower port of the tube.
·Completely remove propeller shaft assembly
from the gearbox.
- Release the clutch slave cylinder 1 without
disconnecting the pipe .
. Remove the counter lever 2 with its rods 3.
- Disconnect .
• the reversing light switch leads 4,
• the earth lead 5 on the gearbox,
· the speedometer coble
6.
- Remove
• the flector clomp bolt,
• the steering gear housing securing bolts.
· Lower the steering gear housing without dis-
connecting the connecting boll heads.
· Remove the clutch housing closure plates.
· Remove the support base 8.0125
• Remove the three Allen bolts that secure the
gearbox to the engine.
WVIW. E. CJ llCJ .OrG