PEUGEOT 504 Series 1970 Workshop Manual page 33

•
la
Correct assembly
ENGINE
REASSEMBLY
Fit the " Perfect-Circle " oil scraper as shown
opposite (gaps at 20 to 50 mm from the centre of
the gudgeon pin hole).
Fit the
rerna1ning
piston
rings
with the gaps
al
approximately
120
from the gap (a) in the
expander ring.
N.B. ·
Never alter the length of the expander.
• The mark on the piston rings must be facing the
crown of the piston.
Fit the piston nng clamp on the piston.
Insert the piston/rod assembly, without turning 1t,
making sure that :
· the arrow is facing the front of the engine,
- the
o rder "1-2-34 ",
marked during dismantling
is respected.
- Whilst pushing the piston down. guide the btg end
onto the crank pin .
.
- Assemble each
brg
end as the rod is fitted .
Tighten the new nuts to 4 m.kg (29 ft.lbs).
N.B. · The marks on the rod and the cap must be
on
the same side.
WVIW. E. CJ llCJ .OrG