PEUGEOT 504 Series 1970 Workshop Manual page 291

REAR AXLE
HUBS· HUB CARRIERS
REMOVAL
- Place the car over a pit or on a car lift
- Raise the rear of the car and chock under the
cross member
- Remove the wheel
- Fit the hub holding tool A on the hub
- Slacken the hub nut, using the socket K36 and
the extension K214, but do not remove it
- Remove the holding tool A.
- Slacken the brake hose nut 1 and disengage the
hose from the support lug
- Open the clamp retaining the hose on the arm
- Disconnect the hand broke cable from the rear
arm
- Remove:
- the anti-squeal spring
- the retaining fork
- the broke pods
- Remove the caliper securing Allen screws
- Withdraw the coliper and, without distorting the
hose, suspend it from the bodywork.
- Remove the drive shaft (class
4
page 12 12 and
12 13).
- Connect the arm to the cross member temporar i I y
using the rods
J.