PEUGEOT 504 Series 1970 Workshop Manual page 196

0
w
lj
::>
w
a.
GEARBO X
RE-ASSEMBL Y
·~J
Jl
- Secure the housing equ ipped with the gear
change forks on support base
8.0311 .
- Install the needle cage in the drive pinion.
·Assemble drive shaft and moinshoft.
·Bring bock 3rd/ 4th gear sliding gear
1
to the
1•Neutral position ...
• Install the intermediate georshoft on this a s -
sembly by passing reverse p in ion through
bock ing plate 2 .
• Mesh the pinions.
·Install the assembly inside the
l.H.
housing,
taking core that the shifting forks correctly
engage the synchroniier rings.
• Install mtermediote georshoft front bearing
outer race 3.
- Lightly smear the mating surfaces of the ho If
houstngs with HPerfect seal• N° 4 compound.
- Install the
R.H.
half hous ing.
• Install and tighten the four housing bolts 4
Tightening torque .
3.60
ft.lbs
(0.5
m.kg)
• Lightly smear the rear face of the clutch
housing with «Perfect seal» N° 4 compound
and secure this housing with six bolts.
Tightening torque :
20.00
ft.lbs (2.75 m.kg).
- Secure the rear bocking plate using four Allen
screws.
Tightening torque : 7.2 ft.lbs (1 m.kg)
504 W orks hop Monuol · Ref 1212 E
WWW.'!::ii CJ Cl .OrG