PEUGEOT 504 Series 1970 Workshop Manual page 163

GEARBOX
REFITTING
- Engage propeller shaft splined sleeve with
the drive shaft.
- Remove plate 8.0403 S.
- Ensure final engagement of propeller shaft
with gearbox.
- Fit four Allen screws equipped with new Bloc-
for washers.
- Tighten the three screws
1
to
43.5
ft.lbs
(6 m.kg).
- Using on hexogono I extension of 8 mm and
the
torque wrench equipped with a fork extension
tighten the fourth screw
2
to 43.5 ft.lbs
(6 m.kg).
· Remove the support base 8.0125.
- Reconnect :
- the earth lead to the gearbox,
- the reversing lights switch leads,
- the speedometer drive coble (the drive worm
should justbe engaged on the pinion, only the
lock nut should be tightened).
- Refit :
- the counter lever,
- the control rods,
· the drain plug equipped with o new seal,
tightening torque
20
ft.lbs
(2.75
m.kg).
WWW.!::::. c:J Cl .OrG