PEUGEOT 504 Series 1970 Workshop Manual page 209

PROPELLER SHAFT
REMOVAL
• Place car on a car lift or o pit.
•
Re~ove
the exhaust pipe assembly and let 1t
rest on :
·the rear cross member, at the rear,
• and at the front on a support tran sversa I ly
positioned.
·Remove the heot dissipation plate.
· Remove both Allen screws securing the rear
axle. Rest the rear part of the connecting tube
on the rear cross member.
• Place o jack under the cross member left hand
support.
- Remove the rear seat cushion.
- Ur.lock al I three securing nuts of the cross
mnmber.
- Remove the front securing nut.
• Raise the tab lock
°'
locking washer.
· Remove the plastic plug from the guide hole.
·Firmly tighten guide rod 8.0906 Kl into this
hole. lock using bar K2.
- LE
AVE THE ROD
IN
THE GUIDE HOLE
• Remove the cross member rear securing nuts
and ·he thrust washers.
- lower the cross member until the bar bears
against the floor.
• The same operations should be carried out on
th• right hand side.
WWW.
Ea~
llC:l .orG
I
I