PEUGEOT 504 Series 1970 Workshop Manual page 431

BRAKES
REPLACING A REAR DISC
Ill - DISC MOUNTED ON INSIDE OF HUB (hub with
access hole to bearing housing bolt (a)).
2nd assembly on all models
REMOVE
- Raise vehicle at rear jacking points.
- Disengage the brake pipe and flexible hose from
the arm.
- Remove brake pads.
- Partially dismantle caliper without disconnecting
the brake pipe and hose.
- Remove shaft nut.
- Remove the shaft, hub, disc assembly after removal
of the bearing housing bolt.
- Dismantle drive shaft using the tools shown
opposite.