PEUGEOT 504 Series 1970 Workshop Manual page 303

RE AR AX LE.
REAR CROSS M EM BER
- Piece o wooden block approximately 10 cm
thick under the end of the rear cross member .
- Remove the guide Kl.
- Then remove the cross member support.
- Remove the intermediate support, in light alloy,
together with its rubber blocks.
- If necessary replace the rubber blocks using
new "Onduflex" washers.
• Tighten the nuts to :
• 23.5 ft. lbs (3.25 m.kg) front block.
• 9 ft.lbs (1.25 m.kg) rear b lock.
WVIW. ~~lllC:J . OrG