PEUGEOT 504 Series 1970 Workshop Manual page 570

'
I
0
w
lj
::>
w
a.
HULL - FRONT PART
REPLACING A COMPLETE BUTTRESS OF THE FRONT FRAMEWORK
PREPARATION
- Removal and refitting of the hull 11 .0201
- Removal and refitting of the front assembly 11.0501
- Replacing the front components
11 .0502
REMOVING THE DETACHABLE COMPONENTS
·Remove
- the bonnet
· the seats
· the mots and floor coverings
INTERVENTION ON THE BENCH
- Place, centre and tighten the hull on the bench,
starting from the points furthest away from the
impact point.
· Straighten the damaged ports. Check, with the
1ock loos e , the progress of the operation by
referring to the fastening holes of the butresses
and the wing valances.
- Check the ploy and the closing of the doors.
CUTTING
· Cut the side brackets flush with :
(o) - the wing valances
(b) - the framework cross piece.
·Cut the front framework flush with :
(c ) ·the front ports of the valances
(d) ·the cross piece supports.
- Cut the lower cross piece flush with
(e) - the supports.
·Cut the lower brockets(f)following their shape.
- Cut the front port of the buttress (g) following
the base of the valance.
·Cut :
(h) ·the battery supports (L.H. side)
(i) . the buttress sole plate at the base of the
bulkheod .
5().l
W orlcsliop Monuol •
Re• 1211 E