PEUGEOT 504 Series 1970 Workshop Manual page 255

DIF FE RENTIAL
RE F ITT ING
- Make sure that the differential oil seals are in
perfect condition
- Smear tallow or bearing grease inside the Ii ps
of each seal
- Grease the drive shaft splines
- Remove the plate 8 .0403 S
- Make sure that the spring is in place in the rear
o f the propeller shaft and grease the splines
- Insert the R.H. drive shaft in the differential
then the propeller shaft
- Secure the connecting tube to the differential ,
placing new Blocfor washers under the nuts.
- Tighten to the nuts to 435ft.lbs (6mkg).
- Secure the differential tothe crossmember us i ng
new counter plates and Blocfor washers
- T ighten the Allen screws to27ft .lbs (3.7Sm.l<g)
- Position the I ips of the counterpl ates on the
edges of the angle supports
- Refit the feed pump
- Refit the broke compensator lever using a new
circlip.
- Pull the drive shaft arm assembly outwards
compre ssing the sliding ioints at the same time
- Engage the spl 1ned end of the shaft in the diHe-
rerit1al housing
- Reposition the arm in the yokes on the cross-
member.