PEUGEOT 504 Series 1970 Workshop Manual page 176

0
GEARBOX
RE-ASSEMBLY
0
-~Jll
PREPARING THE HOUSINGS
CLUTCH HOUSING
Use a flat surface to check the parallel ism of
the front or;id rear faces of the clutch hous ing ,
proceed as indicated on drawing opposite.
The housing must be replaced if the lock of
parallelism exceeds 0.10 mm.
Replacing the guide sleeve
DISMANTLING
- Remove snap ring 1 from guide sleeve 2 using
a screwdriver.
- Remove guide 2 by forcing it out with a press
if
required , use .
- plate HZ, covered with cardboard,
- driver S.
RE-ASSEMBLY
• Place the housing on the bench.
• Insert guide sleeve 2 and force it in place
using installing ring D and a mallet.
• Ins ta
11
a new snap ring.
504 W orkshop M onuol • Re f 1212 E
WVIW. E. CJ llCJ .OrG