PEUGEOT 504 Series 1970 Workshop Manual page 280

I
0
w
IJ
~
w
a.
Supersedes sheet doss 5, page 03 24
DIFFERENT I AL
RE-ASS EMBLY· ADJUSTMENT
· Dip the new oil seal in engine oil.
·Fit this into the thrust plate
1
using the
drift T .
·Top the drift until it abuts on the plate.
• Place the shims (after checking with o Palmer
gouge) on the outer race of the right hand
bearing.
· Insert o newO ring, coated with tall ow between
the thrust plate and the housing.
·Secure this housing with 4 bolts fitted with
new Onduflex washers tighten to 5.8 ft. lbs
(0.8 m.kg).
• Proceed with final tightening of the eight bolts
and four nuts in the sequence indicated below
to 25.37 ft.l bs (3.5 m.kg).
·Slacken the 4 assembling nuts 5, 6, 7, and 8.
·Top with o mallet on the rear housing to obtain
a pe rfect mating between front and rear hou-
sings.
· Re-tight en the four assembling nuts 1n the
some sequence os before (5, 6, 7, 8).
Tightening torque 39.87 ft .l bs (5.5 m.kg).
- Rotate drive pinion several times in both di-
rections.
504 Workshop Manuol ·Ref. l212E