Torsion Shaft - Installation - Rotax 915 i A series Maintenance Manual

Figure 6.47
Support plate
1
3 M40x1.5 collar nut
Special tool 276006
5
Procedure
Step
4 Install the retaining ring A38 on the pro-
peller shaft with special tool part no.
276968.
Figure 6.48
Propeller shaft
1
Retaining ring
3
72–10–00
Page 34
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Propeller shaft
2
4
Protection mushroom
2 Support plate
Special tool 276968
4
TORSION SHAFT — INSTALLATION
Step Procedure
1 Lubricate the torsion shaft with LOCTITE
ANTI SEIZE.
2 Position of the teeth is defined with two
marks, see following figure.
3 Install the torsion shaft into the propeller
gearbox (propeller shaft).
Figure 6.49
Gearbox housing
1
Marking
3
Step Procedure
4
Install O-ring, sealing washer (with sharp
edge showing upwards) and retaining
ring.
5 Hand tighten the hex. screw M12x20 with
washer.
2
Torsion shaft
Effectivity: 915 i A Series
Edition 0/Rev. 0