Pressure And Temperature Sensor - Disconnection; Airbox - Removal - Rotax 915 i A series Maintenance Manual

PRESSURE AND TEMPERATURE
SENSOR — DISCONNECTION
Preparation
• Unplug the connectors of the 2 pressure sensors
and 2 temperature sensors. See
section Wiring harness.
• Loosen and detach the wiring harness (main
strand) from all fastenings (cable ties, retaining fix-
tures) on the engine. See
tion Wiring harness.
• For removal and installation of pressure and tem-
perature sensors, see
Sensors and actuators.
NOTE
The pressure and temperature sensors must
only be removed if absolutely necessary!
Figure 11.37
1 Airbox
3 Pressure sensors
AIRBOX — REMOVAL
Step Procedure
1 Remove the hex. nut M6 attaching the air-
box to the ignition housing along with the
washer.
73–10–00
Page 24
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Chapter 76-50-00
Chapter 76-50-00 sec-
Chapter 76-70-00 section
Temperature sensor
2
Figure 11.38
1 Hex. nut M6
Step Procedure
2 Remove the two 1-ear clamps.
3 Remove the airbox.
Figure 11.39
1-ear clamps
1
NOTE
Remove the nipple and M6x16 screw only if ab-
solutely necessary!
2
Washer 6.4
2 Connecting piece
Effectivity: 915 i A Series
Edition 0/Rev. 0