Rotax 915 i A series Maintenance Manual page 167

Figure 6.65
1 Gearbox
Step Procedure
3 If the clutch can not be completely
pushed on, turn it with the special tool
part no. 276962 and push it to the end
stop.
NOTE
If necessary, use a soft-faced ham-
mer (light hammer blows only).
NOTE
When all steps are done correctly, then the outer
teeth of the overload clutch align with the seal-
ing surface of the gear housing. If incorrect, the
overload clutch will be raised over the sealing.
In this case it needs to be investigated, which
pairing is mounted wrong and it has to be fixed.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Overload clutch
Figure 6.66
Special tool 276962
1
2
Overload clutch
72–10–00
Page 41
August 01 2018