Rotax 915 i A series Maintenance Manual page 41

Classification of "On-Condition" parts at maintenance/repair:
Actual wear [%] is greater than or equal to the
max. permissible wear [%] calculated from the
table
Actual wear [%] is smaller than the max. permis-
sible wear [%] calculated from the table
NOTE
A negative result means that the actual dimension F is within the new dimension
tolerance D and the part can be used again.
Example
The hours of operation are indicated with 300 h. The determined percentage of maximum
permissible wear is therefore 36 %.
New dimension (max.)
Wear limit
Actual dimension
Actual wear
This part must be replaced because it is excessively worn for only 300 hours of operation.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Parts must be replaced
Parts can be used again
B
28.03 mm (1.1035 in.)
C 28.10 mm (1.1062 in.)
F
28.07 mm (1.1051 in.)
57.1%
00–00–00
Page 21
August 01 2018