Rotax 915 i A series Maintenance Manual page 500

OIL HOSES
REMOVAL OF THE OIL HOSES
ATTENTION
The oil hoses are not included in the delivery
of the engine and must be maintained accord-
ing to the aircraft manufacturer's instructions.
Remove the oil hoses and clamps accord-
ing to the instructions in the aircraft manu-
facturer's manual.
REMOVAL OF THE OIL LINE (STEEL
LINE)
ATTENTION
The steel oil lines, which are included in the
delivery, are only removed if they are damaged,
maintenance or for cleaning.
Step Procedure
1
Remove the cable clamp for supporting
the line on the side of the gearbox.
2 Loosen the M10 banjo bolt and gasket
ring on the governor flange. See
61-20-00 section
3 Loosen the banjo bolt on the oil pump
housing and remove it along with the gas-
ket rings.
See Chapter 61-20-00 section
4 Loosen cap nut from the turbo oil suction
line.
79–00–00
Page 24
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Chapter
Governor.
Governor.
Figure 22.33
Governor pressure oil
1
line
M10 banjo bolt
3
5 Turbo oil suction line
Step Procedure
5
Remove the cable clamp from the turbo
oil lines.
Figure 22.34
Turbo pressure oil line
1
Cable clamp
3
Cable clamp
2
Turbo pressure oil line
4
6 Cap nut
2
Turbo oil suction line
Effectivity: 915 i A Series
Edition 0/Rev. 0