Fuel Pressure Regulator Assy. - Installation - Rotax 915 i A series Maintenance Manual

Step Procedure
6 Fasten the heat shield with 4 Allen screws
M5x12 and lock washers 5.3.
Tightening torque 5 Nm (44 in. lb.)
Figure 11.68
1 Allen screw M5x12
3 Heat shield
Step Procedure
7
Fix the fuel pressure regulator for cylin-
ders 2 and 4 with an Allen screw M5x35.
Tightening torque 5 Nm (44 in. lb.).
Figure 11.69
1 Allen screw M5x12
3 Cover
73–10–00
Page 38
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Washer 5.3
2
Washer 5.3
4
Allen screw M5x35
Step Procedure
8 Install the cover with an Allen screw
M5x12 and lock washer 5.3.
Tightening torque 5 Nm (44 in. lb.)
Figure 11.70
1 Allen screw M5x12
3 Cover
FUEL PRESSURE REGULATOR ASSY. —
INSTALLATION
The fuel pressure regulator assy. is installed and re-
moved in the same way. The following should be
noted.
Step Procedure
1 Fix the fuel pressure regulator assy. with
an Allen screw M5x35 and an Allen screw
M5x45.
Tightening torque 8 Nm (70 in. lb.).
NOTE
Tighten the Allen screw M5x45 first. The heat
shield is screwed on along with the front Allen
screw M5x35.
2
Washer 5.3
Effectivity: 915 i A Series
Edition 0/Rev. 0