Installation; Needle Sleeve - Installation; Ball Bearing - Installation - Rotax 915 i A series Maintenance Manual

INSTALLATION

ATTENTION
The oil inlet flange must not be installed flush
and the O-ring must not be pinched.
ATTENTION
Longer screws on the oil inlet flange could de-
stroy it.
ATTENTION
All gaskets, O-rings and oil seals must be
replaced!
NEEDLE SLEEVE — INSTALLATION
Procedure
Step
1 Lubricate the new needle sleeve.
2 Apply the puller part no. 876489 on the
governor side.
3 Place the press-in mushroom part no.
877597 on the needle sleeve and fix it
with the hex. nut.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Puller part no. 876489
1
3 Washer
Press-in mushroom
5
part no. 877597
Figure 3.13
Step Procedure
4 The needle sleeve is pressed in as far as
it will go by turning the hex. screw
clockwise.
BALL BEARING — INSTALLATION
Step Procedure
1 Apply the puller part no. 876489 on the
governor side.
2 Insert the press-in mushroom part no.
877595 into the roller bearing and fix it
with the hex. nut.
3 The ball bearing is pressed in as far as it
will go by turning the hex. screw
clockwise.
Figure 3.14
Puller part no. 876489
1
3 Washer
Press-in mushroom
5
part no. 877595
2
Hex. screw
4
Hex. nut
6
Needle sleeve
2
Hex. screw
4
Hex. nut
6 Ball bearing
61–20–00
Page 13
August 01 2018