Rotax 915 i A series Maintenance Manual page 433

INJECTORS — INSPECTION
Preparation
Carry out a general visual inspection:
• Corrosion or damage to the wiring, connector contacts or connections
• Check the labelling of the injectors
Functional test
• Check flow rate
• Leak-proofness
• Check the "spray pattern" using the map
Risk of damage to engine management system components! There is a risk of a permanent bypass
Voltage and resistance test
The internal resistance is about 12 Ω.
DOUBLE IGNITION COIL — INSPECTION
Preparation
Carry out a general visual inspection:
• Corrosion or damage to the wiring, connector contacts or connections
• Check the labelling of the connector
Measurement
Measuring points
Primary side
Secondary side
Between Primary side
and Secondary side
FUEL PUMP — INSPECTION
To do this, see Chapter 73-10-00 section Fuel pump and
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
ATTENTION
(fuel pressure surge).
Double ignition coil
Resistance
0.6 Ω +/- 0.6 Ω
8.2 kΩ +/- 0.82
kΩ
Infinite
Figure 18.37
distribution.
76–70–00
Page 25
August 01 2018