Loctite Application Procedure - Rotax 915 i A series Maintenance Manual

LOCTITE APPLICATION PROCEDURE

The following describes common procedures used when working with LOCTITE products.
NOTE
Always use proper strength LOCTITE product as recommend in this Manual.
Thread locker application
Thread locker application for uncovered holes (Bolts and nuts).
Figure 1.5: Application for uncovered holes (Bolts and nuts)
Step
00–00–00
Page 24
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Observe the instructions of the manufacturer!
2
Apply here
1
Procedure
1 Clean threads (bolt and nut) with solvent.
2 Apply LOCTITE 7063 on threads and allow to dry.
3
Choose proper strength LOCTITE thread locker.
4
Fit bolt in the hole.
5
Apply a few drops of thread locker at proposed tightened nut engagement
area.
6
Position nut and tighten as required.
1
B00002
Do not apply
2
Effectivity: 915 i A Series
Edition 0/Rev. 0