Rotax 915 i A series Maintenance Manual page 347

Figure 14.42
Figure 14.43
1 Preformed hose 1
3 Preformed hose 3
Spring type hose
5
clamp
FINISHING WORK
See Maintenance Manual Line for the en-
gine type 915 i A Series.
• Put the 2 cable ties on the knock sensor line. See
Chapter 76-50-00 section Wiring
• Install the double ignition coils and spark plug con-
nectors. See Chapter 74-20-00 section Ignition
unit.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Preformed hose 2
4
Preformed hose 4
harness.
• Install the air filter with the heat shield. See the cur-
rent Maintenance Manual Line.
• Fill with coolant. See relevant Maintenance Man-
ual Line for the 915 i A Series engine type.
• Service the engine cooling system. See relevant
Maintenance Manual Line for the 915 i A Series
engine type.
• Fill with fuel. See relevant Maintenance Manual
Line for the 915 i A Series engine type.
• Install the fuel line assy. See
section Fuel system.
• Install the 1-ear clamps.
• Install the cable ties for the fuel pressure regulator
reference hose. See Chapter 73-10-00 section
Fuel system.
• Install the wiring harness. See
section Wiring harness.
• Install the fuel hose inlet and return hose. See
Chapter 73-10-00 section Fuel
• Carry out an engine test run. See relevant Mainte-
nance Manual Line for the 915 i A Series engine
type.
Chapter 73-10-00
Chapter 76-50-00
system.
75–00–00
Page 29
August 01 2018