Removal Of The Hydraulic Valve Tappet - Rotax 915 i A series Maintenance Manual

Step Procedure
4 Install the puller spindle in the piston pin
and mount M6 extracting nut (part no.
877155).
5 Turn the puller spindle clockwise to pull
the piston pin out of the conrod into the
puller sleeve until the piston can be taken
off.
Figure 9.5
Piston pin puller
1
3 Pistons
Step Procedure
6 Loosen the nut and remove the puller.
Remove the piston and put it down with
the corresponding cylinder.
REMOVAL OF THE HYDRAULIC VALVE
TAPPET
NOTE
Store and identify the hydraulic valve tappet so
that it can be installed in the same place when it
is reused.
Step Procedure
1 Remove the hydraulic valve tappet from
the housing with the circlip remover part
no. 976380.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Puller spindle
2
Figure 9.6
Circlip remover
1
Hydraulic valve tappet
2
72–30–10
Page 7
August 01 2018