Rotax 915 i A series Maintenance Manual page 315

INSTALLATION
KNOCK SENSOR — INSTALLATION
See Chapter 76-70-00 section Sensors and actua-
tors and Chapter 76-50-00 section Wiring
SPARK PLUG — INSTALLATION
See Maintenance Manual Line for the en-
gine type 915 i A Series. Chapter 12-20-00
Installation of spark plug.
SPARK PLUG CONNECTOR AND
IGNITION CABLE ASSY. —
INSTALLATION
ATTENTION
Risk of damage to spark plug connector! The
spark plug connectors must only be installed
by hand or using an equivalent tool, that has
no pointed or sharp edges.
Step Procedure
1 Pull silicon coated glass-fibre sleeves on
the ignition cables Top and Bottom.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
harness.
Spark plug connector
1
Figure 13.14
Step Procedure
2 Screw ignition cable into coil.
3 Slide rubber seal over coil.
4 Screw the spark plug connector on the
ignition cable assy. and secure it with a
cable tie.
5 Route the ignition cable assy. correctly
and secure it with a cable tie.
Figure 13.15
1 Cable ties
DOUBLE IGNITION COIL —
INSTALLATION
The double ignition coil is installed and removed in
the same way. The following should be noted.
NOTE
The red cable is positive (+), the black cable is
negative (-). Double ignition coils are labelled +
and -!
Step Procedure
1 Plug in the double ignition coil
connectors.
Ignition cable assy.
2
Ignition cable assy.
2
74–20–00
Page 13
August 01 2018