Rotax 915 i A series Maintenance Manual page 419

Figure 18.10
Manifold temperature
1
sensor
Step Procedure
3 Unscrew the temperature sensor with an
SW 19 open-ended spanner part no.
876130 (or similar tool) and remove it to-
gether with the sealing ring and the con-
nector bracket.
4
Close the threaded bore with the appro-
priate protective covering.
Figure 18.11
Temperature sensor
1
3 Connector bracket
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Cable ties
2 Sealing ring
EXHAUST GAS TEMPERATURE
SENSOR (EGT1/EGT2/EGT3/EGT4) —
REMOVAL
Installation position: Double ignition coils, exhaust
pipes
Step Procedure
1 Remove the respective wiring harness
plug from the corresponding exhaust gas
temperature sensor (EGT1/EGT2/EGT3/
EGT4).
See Chapter
ness (main strand).
Figure 18.12
EGT wiring harness
1
plug
Step Procedure
2 Press the metal bracket and separate the
connectors.
3
Carefully pull exhaust gas temperature
sensor (EGT) out of the locking plate.
76-50-00 section Wiring har-
76–70–00
Page 11
August 01 2018