Stator Assy. - Installation - Rotax 915 i A series Maintenance Manual

Figure 2.30: TYPICAL
Oil seal positioned
1
STATOR ASSY. — INSTALLATION
Step Procedure
1 Thread in the cable and then secure ad-
justment screw M4x8 with LOCTITE 243
and tighten them.
Tightening torque 1.5 Nm (13 in.lb.).
Figure 2.31
Rubber grommet
1
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Insertion jig
2
Adjustment screw
2
M4x8
Step Procedure
2 Position the stator assy. Then secure 6
Allen screws M5x30 including washers A
5.5 with LOCTITE 243 and tighten them.
Tightening torque 5 Nm (44 in.lb.).
The separation paper of the two generator coils are
in proximity with the water pump gear.
NOTE
When positioning, make sure there is as little
spacing possible between the cable lead-
through in the ignition cover and the cable con-
nection to the coils.
Figure 2.32
Separation paper between the two generator coils
1
3 Allen screw M5x30
Step Procedure
3 Install the distance sleeve, disk springs
and washer.
4
Washer A 5.5
24–20–00
Page 17
August 01 2018