Cylinder Head - Removal - Rotax 915 i A series Maintenance Manual

NOTE
There is an O-ring under the elbow flange.
Remove the connector brackets on cylinder 3/4.
Figure 8.8
Hex/Torx flange
1
screw M6x20
Elbow flange
3
Step Procedure
11 Remove the knock sensor from cylinder
1. To do this, see
tion Sensors and
CYLINDER HEAD — REMOVAL
Procedure
Step
1 Loosen the M6x30 screw and washer.
2 Remove the valve cover with the large
and small O-rings.
72–30–00
Page 10
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Coolant elbow
Chapter 76-70-00 sec-
actuators.
Figure 8.9: Typical
1 M6x30 screw
3 Valve cover
ATTENTION
Do not lose the O-rings!
Step Procedure
3 Loosen 2 hex. nuts.
4 Loosen 2 M8 collar cap nuts inside the
valve cover (diagonally).
Figure 8.10
1 Hex nuts
2 6.0 washer
4 O-rings
Collar cap nuts
2
Effectivity: 915 i A Series
Edition 0/Rev. 0