Rotax 915 i A series Maintenance Manual page 402

INSPECTION
ATTENTION
When work is carried out on the components
of the engine management system, there is a
risk that these might get damaged. Never put
measuring probes in plug connectors or use
other "aids" to carry out tests in the plug
connectors.
ATTENTION
All electronic components must be in the origi-
nal state. Any modification e.g. to the wiring
harness can lead to incorrect inputs or operat-
ing faults.
General visual inspection.
See Maintenance Manual Line for the en-
gine type 915 i A Series Chapter 05-00-00
and 12–20–00.
NOTE
It must be ensured that all plug-in connections
are properly crimped with the cables. (There
must be no bent, deformed or loose pins in the
plug connections!)
Electric test
The electric test of the wiring harness takes place in
the installed state.
Step Procedure
1 Unplug the wiring harness at the ECU
and connect adapter part no. 277012.
2 Wire harness can be tested using an
Ohmmeter.
76–50–00
Page 18
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Figure 17.27
Adapter
1
Effectivity: 915 i A Series
Edition 0/Rev. 0