Controller Connector - Assembly - Rotax 915 i A series Maintenance Manual

Hide thumbs Also See for 915 i A series:

Table of Contents

Tighten lock nut M5.

Tightening torque 3 Nm (27 in. lb.) and

then open counter-clockwise by 1.5 turns.

Slip on the full length of the black protec-

Figure 2.33: TYPICAL

Distance sleeve

Washer 5.1/15.5/2.5

CONTROLLER CONNECTOR —

Position the filler plug correctly. Position

wires correctly to connector pin labels,

using previously applied marks on wire

Thread the lines through the insulator

Make the cable sleeves latch.

Cables of generator B are thicker than cables of

generator A. Cables of generator B are yellow..

August 01 2018

MAINTENANCE MANUAL HEAVY

Disk springs

Connector receptacle

Cable sleeves

Install the orange lock.

At malfunctions such as wire breakage and

faulty plugs, the particular damage can be

Cable must be long enough after repair is made.

Repair of malfunctions with the tools mentioned

here must conform to the aircraft standards of

the respective country.

See also relevant Illustrated Parts Catalog

for the 915 i A Series engine type.

Insulator (rubber)

Effectivity: 915 i A Series

Edition 0/Rev. 0

Chapters

Table of Contents