Rotax 915 i A series Maintenance Manual page 468

Figure 21.14
COMPRESSOR WHEEL — CHECK
Step Procedure
1 Apply slightly a radial pressure onto the
shaft whereby it must not contact the
compressor housing.
Check the complete circumference of
360°.
Figure 21.15
CHECKING THE WASTEGATE LEVER
Procedure
Step
1 Check the wastegate lever for free move-
ment. If it does not move freely, lubricate
the axle of the waste gate with LOCTITE
ANTI SEIZE 8151.
78–20–00
Page 10
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Figure 21.16
CHARGER SHAFT — CHECK
Step Procedure
1 Record the readings in the appendix.
Figure 21.17
IMPELLER SHAFT — CHECK
The bearings are tested by means of the pressure
drop measuring method.
Effectivity: 915 i A Series
Edition 0/Rev. 0