Rotax 915 i A series Maintenance Manual page 502

OIL HOSES — INSTALLATION
ATTENTION
Ensure that the hoses are installed without
tension and are not scuffed. Observe minimum
distances, e.g. 2 mm (0.0787 in.) from the
housing.
Step Procedure
1 Install the oil hoses and clamps according
to the instructions in the aircraft manufac-
turer's manual.
2 Use original hoses with the correspond-
ing aircraft manufacturers certification for
replacement.
3 Only use suitable clamps, or crimp con-
nections to fasten the hoses.
OIL LINE (STEEL LINE) INSTALLATION
Step Procedure
1 Install the governor pressure oil line with
the M10 banjo bolt and gasket ring on the
governor flange. Tightening torque 17 Nm
(150 in. lb).
See also Chapter 61-20-00 section
Governor.
2 Install the governor pressure oil line and
turbo pressure oil line with the M10 banjo
bolt on the oil pump housing with the gas-
ket rings. Tightening torque 12 Nm (106
in. lb).
See also Chapter 61-20-00 section
Governor.
79–00–00
Page 26
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Figure 22.36
Governor flange
1
Sealing ring A 10x14
3
Banjo bolt M10x1x34
5
7 Lock washer A8
Oil pump
9
Banjo bolt M10x1x23
2
Governor pressure oil
4
line
6 Cable clamp
Hex/torx-flange screw
8
M8x16
10 Turbo pressure oil line
Effectivity: 915 i A Series
Edition 0/Rev. 0