Rotax 915 i A series Maintenance Manual page 473

Figure 21.24
Muffler assy.
1
3 Exhaust bracket
Procedure
Step
4 Install exhaust manifold using Allen
screws M8x30 with hex. nuts M8 and
washers. Apply LOCTITE ANTI SEIZE to
the screws. Tightening torque 25 Nm (18
ft. lb).
Image Tag Expected within Figure Tag
Figure 21.25
Turbocharger flange
1
3 M8 hex. nut
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2 Tension clamp
2
Washer
Step Procedure
5 Re-establish attachment (turbocharger
bracket engine suspension frame (not
supplied with engine). Tightening torque
as specified by the aircraft manufacturer.
6 Install spring and ball of pressure oil line,
see Chapter 79-00-00
installation.
7 Re-connect the two oil lines for turbo-
charger on the oil pump, see Chapter 79-
00-00 Oil line (steel line)
8 Install turbo suction oil line with clamp,
M5x20 screw and new M5 lock nut on tur-
bocharger bracket, see Chapter 79-00-00
Oil line (steel line)
9 Install hose on wastegate regulator assy.
Figure 21.26
Turbo pressure line
1
Wastegate regulator
3
Cable clamp
5
Oil line (steel line)
installation.
installation.
2
Suction oil line
Hose (wastegate
4
regulator)
78–20–00
Page 15
August 01 2018