Rotax 915 i A series Maintenance Manual page 513

ELECTRIC STARTER
Preparation
• Starter, Master and Lane selector switches must
be "OFF"!
• Disconnect the battery (negative pole)
ELECTRIC STARTER — REMOVAL
Step Procedure
1 Disconnect the positive pole on the elec-
tric starter.
Figure 23.3: TYPICAL
Positive (+) cable
1
3 Washer
ATTENTION
Hold the M5x145 hex. screw still with a suitable
tool. If the hex. screw is turned, then the elec-
tric starter itself is unscrewed!Do not unscrew
or remove the long M5 screws!
Step Procedure
2 Loosen the 2 hex. nuts M5 on the rear of
the crankshaft housing.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Hex. screw
Figure 23.4
1 Electric starter
3 Hex. nuts M5
ATTENTION
Do not tap the electric starter with a hammer,
the adhering magnets can come off.
NOTE
If the O-ring (fig. 3) sticks, first press the electric
starter gently down with a screwdriver and then
pull off the starter by hand.
2 Crankshaft housing
4
Hex. screw M5 x 145
80–00–00
Page 5
August 01 2018