Removal; Governor - Removal; Governor Flange - Removal - Rotax 915 i A series Maintenance Manual

REMOVAL

GOVERNOR — REMOVAL
See "Documentation of aircraft
manufacturer".
ATTENTION
Follow the governor manufacturer's instruc-
tions for maintenance, inspection and repair.
GOVERNOR FLANGE — REMOVAL
Step Procedure
1 Loosen banjo bolts M10x1x19 with gas-
ket rings on both sides of the governor
flange and oil pump housing and remove
the oil line.
2 Loosen 4 Allen screws M6x20 and 2 Allen
screws M6x16 for the flange fastening of
the oil feed line.
3 Remove the governor flange with the O-
ring and spacer behind it.
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Figure 3.4
Governor flange
1
Sealing rings A10x14
3
Banjo bolt M10x1x34
5
7 Lock washer A8
Oil pump housing
9
Figure 3.5
1 Allen screws M6x16
Governor flange
3
O-ring 32x4-N
5
Banjo bolt M10x1x23
2
Governor pressure oil
4
line assy.
6 Cable clamp 8/M8
Hex./Torx-flange screw
8
M8x16
10 Turbo pressure oil line
2
Allen screws M6x20
O-ring 7x2-N
4
6 Spacer 25/31.95/13
61–20–00
Page 7
August 01 2018