Rotax 915 i A series Maintenance Manual page 169

Figure 6.69
Extractor part no.
1
877615
Needle bearing
3
Step Procedure
4 Secure M5x12 countersunk screw includ-
ing the retaining washer with LOCTITE
243 and tighten it. Tightening torque 5
Nm (44 in.lb.)
Figure 6.70
M5x12 countersunk
1
screw
Effectivity: 915 i A Series
Edition 0/Rev. 0
BRP-Rotax
MAINTENANCE MANUAL HEAVY
Press-in mushroom
2
part no. 276000
2
Washer
FINISHING WORK
Install gearbox assy., see relevant Mainte-
nance Manual Line for the engine type 915
i A Series Chapter 05-50-00.
Fill with operating fluids or check filling lev-
els. See relevant Maintenance Manual
Line for the engine type 915 i A Series
Chapter 12-10-00 section Adding operat-
ing fluids.
Carry out an engine test run. See relevant
Maintenance Manual Line for the engine
type 915 i A Series.
• After the engine test run, check the engine and
gearbox for leaks.
72–10–00
Page 43
August 01 2018