Rotax 915 i A series Maintenance Manual page 398

Figure 17.16
1 Lock
EGT CONNECTOR AND IGNITION COIL
— DISCONNECTION
See Chapter 74-20-00 section ignition
Wiring harness designation:
• EGT_1, EGT_2
• EGT_3, EGT_4
• COIL_1
• COIL_2
• COIL_3
• COIL_4
TEMPERATURE SENSOR —
DISCONNECTION
Wiring harness designation:
• CTS
Procedure
Step
1 Disconnect the plug connection to the
temperature sensor.
76–50–00
Page 14
August 01 2018
BRP-Rotax
MAINTENANCE MANUAL HEAVY
2
Lever
unit.
Figure 17.17
Temperature sensor
1
INJECTOR — DISCONNECTION
Wiring harness designation:
• INJ_1 to INJ_8
Preparation
• Injector – disconnection, to do this, see
73-10-00.
THROTTLE POTENTIOMETER (TPS) —
DISCONNECTION
Wiring harness designation:
• Throttle potentiometer (TPS)
ATTENTION
Do not damage the wiring harness. Always cut
cable ties on the side of the support plate fac-
ing away from the wiring harness.
Step Procedure
1 Cut 2 cable ties on the airbox.
2 Unplug the throttle potentiometer.
• Lift the latches
• Unplug the connector
Chapter
Effectivity: 915 i A Series
Edition 0/Rev. 0